Installation guide

20 Upgrade Manual
10 Power Up and Verify the System
Turn on the system, run console diagnostics, and issue the test command. Check
the system configuration against the old configuration. Boot the operating
system and run VET.
Example 2 Verifying the System
P00>>> sho sys_model_num ➏
sys_model_num GS60E
If it is not set to GS60E on power-up, the map will show this as follows: Use the
set sys model number command to set the model to GS60E, as shown below.
. . . . . . . . . . . . . . . . C3
. A1 A0 . . . . . . ILV
. 4GB 4GB . . . . . . 8GB
AlphaServer GS60 8-6/525/4, Console V5.5-17 12-AUG-1999
15:03:35
SROM V2.3, OpenVMS PALcode V1.61-5, Tru64 UNIX PALcode V1.54-3
System Serial = qv, OS = OpenVMS, 15:52:29 August 23, 1999
P00>>> sho sys_model_num
sys_model_num GS60 (or AS8200)
P00>>> set sys_model_num GS60E
P00>>> test
[test for all system devices appears]
P00>>> boot