Technical information

FRU Removal and Replacement 8-15
To Gain Access to the System Chassis
1. Open the front door of the cabinet.
2. Pull out the stabilizer bar
➊ at the bottom of the cabinet until it stops.
3. Extend the leveler foot at the end of the stabilizer bar to the floor.
4. Snap out the front bezel
➋.
5. Remove and set aside the two screws
➌ (one per side), if present, that
secure the system to the cabinet.
6. Pull the system out until it locks.
NOTE: In a 4-system H9A10 cabinet, remove the top overhang bezel by
loosening the two screws ➊.
Figure 8–6 H9A10 Overhang Bezel
PK1211
1