Specifications

Index-2
Console tests, 7-15
Console, selecting, 2-15
Consoles, switching between, 2-14
Control panel, 1-8
Control panel messages, 2-3
Controls
halt button, 1-9
power button, 1-8
reset button, 1-9
Covers
removing from pedestal or rack, 5-8
removing from tower, 5-7
CPU card, 1-11
CPU slot locations, 5-18
CPUs
configuring, 5-19
installing, 5-20
crash command (SRM), 7-22
Crash dump, 7-23
D
Date and time, setting in AlphaBIOS, 2-32
Device naming, SRM, 2-26
Diagnostic tests, 7-14
Diagnostics, 7-2
Dial-in configuration, 4-22
Dial-out alert, 4-24
DIMMs
configuring, 5-23
installing, 5-26
Disk cage, installing, 5-38
Display device, selecting, 2-15
Display device, verifying, 2-16
Display System Configuration screen, 2-30
DPR, 4-3
Dual-port RAM, 4-3
E
EEPROMs, 4-3
ei*0_inet_init environment variable, 3-6
ei*0_protocols environment variable, 3-7
Electrical specifications, 8-7
Enclosure panels
removing, 5-2
removing from a pedestal, 5-5
removing from a tower, 5-3
env command (RMC), 4-18
Environment, monitoring, 4-18
Environmental specifications, 8-6
Error beep codes, 7-2
Error log information, RMC, 4-3
Error messages
from RMC, 7-8
SROM, 7-11
Errors reported by operating system, 7-29
Escape sequence (RMC), 4-10
Event log, 7-12
ew*0_inet_init environment variable, 3-6
ew*0_protocols environment variable, 3-7
F
Factory-installed software (FIS), 3-1
Fail-safe loader, 7-4
Fan failure, 7-25
Firm bypass mode, 4-8
Firmware
updating, 6-1
updating from AlphaBIOS, 6-8
updating from OpenVMS system disk, 6-9
updating from SRM, 6-7
updating using BOOTP, 6-10
updating using MOP, 6-11
Firmware update utility, 6-4
Firmware updates
AlphaBIOS Web location, 6-2
Internet access, 6-2
manual, 6-6
quarterly update service, 6-2
sources of, 6-2
Flash ROM, updating, 6-6
Flash SROM, 2-5
FRUs, displaying, 7-16, 7-19
H
Halt button, 1-9
Halt in/out command (RMC), 1-9
Halt, remote, 1-9, 4-21
hangup command (RMC), 4-23
Hard disk setup, AlphaBIOS, 2-33
Hard disk troubleshooting, 7-32
Hard drives, 1-17
installing, 5-15