Specifications

Configuring and Installing Components 5-27
WARNING: To prevent injury, access is limited to persons who
have appropriate technical training and experience. Such
persons are expected to understand the hazards of working
within this equipment and take measures to minimize danger to
themselves or others.
WARNING: Memory DIMMs have parts that operate at high
temperatures. Wait 2 minutes after power is removed before
touching any module.
WARNING: To prevent injury, unplug the power
cord from each power supply before installing
components.
V @ >240VA
WARNING: High current area. Currents exceeding
240 VA can cause burns or eye injury. Avoid contact
with parts or remove power prior to access.
1. Shut down the operating system and turn off power to the system. Unplug
the power cord from each power supply.
2. Access the system chassis by following the instructions in Section 5.2.
3. Remove the fan cover and the system card cage cover.
4. Use Figure 5–11 or Figure 5–12 to determine where sets of memory DIMMs
should be installed. Begin with the lowest numbered set.
5. Release the clips
➊ securing the appropriate MMB ➋ and slide out the
MMB. See Figure 5–13.
6. Release the clips
➌ on the MMB slot where you will install the DIMM ➍.
Continued on next page