Specifications

Configuring and Installing Components 5-13
1.
Loosen the three Phillips screws
➊ that secure the power supply bracket.
(There is no need to remove the screws.) Remove the bracket
➋.
2.
If you are installing a new supply, remove the screw and blank cover
➌. If
you are replacing a power supply, release the latch
➎ on the supply and pull
the supply out of the system.
3.
Insert and seat the new power supply
➍.
4.
Swing the latch
➎ to lock the power supply into place. Tighten the captive
screw on the latch.
5.
Plug the AC power cord into the supply. Wait a few seconds for the POK
LED to light.
Verification
Check that both power supply LEDs are lit.