Specifications

4-28 Compaq AlphaServer ES40 Owner’s Guide
4.7 Resetting the RMC to Factory Defaults
If the non-default RMC escape sequence has been lost or forgotten,
RMC must be reset to factory settings to restore the default escape
sequence.
WARNING: To prevent injury, access is limited to persons who
have appropriate technical training and experience. Such
persons are expected to understand the hazards of working
within this equipment and take measures to minimize danger to
themselves or others.
The following procedure restores the default settings:
1. Shut down the operating system and press the Power button on the operator
control panel to the OFF position.
2. Unplug the power cord from each power supply. Wait until the +5V Aux
LEDs on the power supplies go off before proceeding.
3. Remove enclosure panels as described in Chapter 5.
4. Remove the system card cage cover and fan cover from the system chassis,
as described in Chapter 5.
5. Remove CPU1 as described in Chapter 5.
6. On the system board, install jumper J25 over pins 1 and 2. See Figure 4–4
for the location of J25. (The default jumper positions are shown.)