System information

Server Management Console
4-9
4.4 Remote Management Console Commands
The remote management console supports the following commands:
clear {alert, port}
disable {alert, reboot, remote}
enable {alert, reboot, remote}
halt {in, out}
hangup
help or ?
power {off, on}
quit
reset
send alert
set {alert, baud, dial, escape, init, password, wdt}
status
Explanations and examples of the RMC command set follow.
clear alert
The clear alert command clears the current alert condition and causes the RMC to
stop paging the remote operator. If the alert is not cleared, the RMC continues to
page the remote operator every 30 minutes, assuming both remote access and alerts
are enabled.
Example:
RCM> clear alert
RCM>
clear port
The clear port command uses the console port modem control signals to clear any
“stuck” conditions on the system’s COM1 port. The object is to attempt to free the
port using the COM1 port modem control lines if it is currently locked by some
application program without resetting the entire system.
Example:
RCM> clear port
RCM>