System information

4-6
AlphaServer 800 Service Guide
Table 4-1 Dial and Alert String Elements
String Elements Description
Dial String
ATXDT (Enter characters either in all uppercase or all lowercase).
AT = Attention
X = Forces the modem to dial “blindly” (not look for the
dial tone). Enter this character if the dial-out line modifies
its dial tone when used for services such as voice mail.
D = Dial
T = Tone (for touch-tone)
, = Pause for 2 seconds.
9, In the example, “9” gets an outside line. Enter the number
for an outside line if your system requires it.
15085553333 Dial the paging service.
Alert String
,,,,,, Pause for 12 seconds for paging service to answer (each
comma (,) provides a two second delay.
5085553332# “Message,” usually a call-back number for the paging
service. The alert string must be terminated by the #
character.
; Return to console command (;) character must be used to
terminate the string.
4. Using the RMC command set password, assign a password of up to 14
characters that will be stored in nonvolatile memory. This password must be set
before access through the modem port can be enabled.
5. Using the RMC command enable remote, enable access to the to RMC modem
port. This also allows the RMC to automatically dial the phone number set by
the dial string upon detection of an alert condition and to send the modem
initialization string to the modem.
6. Using the RMC command enable alert, enable alert condition to page an
external operator.