System information

System Configuration and Setup
6-29
When configuring the SCSI bus, note the following:
• If you plan to connect the internal hard disk drives to a RAID controller option
or a SCSI controller other than the onboard controller, you need to use cable
PB8HA-DA. This cable provides additional length needed to reach the
connector on the controller option. Figure 6-7 shows the cable routing from the
hard disk backplane to the storage controller option.
• If you plan to extend a SCSI bus from a controller through either of the wide
SCSI breakouts at the rear of the enclosure, cable BC25V-1H provides a wide
68-pin connector, as shown in Figure 6-8.
• If you plan to extend a SCSI bus from a multi-channel controller to external
devices through a vacant PCI/EISA slot bulkhead connector, cable KZPAC-SB
provides two 68-pin (Honda miniature) connectors on a bulkhead connector, as
shown in Figure 6-9.
• Two of the three 5.25-inch half-height removable-media device slots can be
used to provide room for one 5.25-inch full-height device. Remove the divider
as shown in Figure 6-10 to convert from two half-height to one full-height slot.