System information

System Configuration and Setup
6-23
• For systems running Windows NT—Select the following menus:
a. From the AlphaBIOS Setup menu, select Utilities.
b. From submenu, select Run Maintenance Program. Insert the ECU
diskette for Windows NT (AK-PYCJ*-CA) into the diskette drive and
select Run ECU from floppy.
• For systems running OpenVMS or DIGITAL UNIX—Start the ECU as
follows:
a. Insert the ECU diskette for OpenVMS or DIGITAL UNIX (AK-
Q2CR*-CA) into the diskette drive.
b. Enter the ecu command (or ecu -g command to force output to the
graphics display). The ecu command will load the AlphaBIOS console
and then load and start the ECU from the diskette drive.
3. Complete the ECU procedure according to the guidelines provided in the
following sections.
• If you are configuring an EISA bus that contains only EISA options, refer to
Table 6-2.
NOTE: If you are configuring only EISA options, do not perform Step 2 of
the ECU, “Add or remove boards.” (EISA boards are recognized and
configured automatically.)
• If you are configuring an EISA bus that contains both ISA and EISA
options, refer to Table 6-3.
4. After you have saved configuration information and exited from the ECU:
• For systems running Windows NT—Remove the ECU diskette from the
diskette drive and boot the operating system.
• For systems running OpenVMS or DIGITAL UNIX—Remove the ECU
diskette from the diskette drive. Return to the SRM console firmware as
follows:
a. From the CMOS Setup menu, press F6 to enter Advanced CMOS setup.
b. From the Advanced CMOS Setup menu, select OpenVMS (SRM).
c. Press F10 to save the change.
d. When the “Power cycle the system to implement the change” message
is displayed, press the Reset button. (Do not press the On/Off button)
Once the console firmware is loaded and device drivers are initialized,
you can boot the operating system.
5. Verify that the new options are configured correctly.