Service manual

D-18 AlphaServer GS80/160/320 Service Manual
D.3.2 Using the SCM Update Command
The SCM update command may be used from the master SCM to update
specific firmware in the system. The firmware file must be downloaded
to the master SCM local terminal port. If a microprocessor is in FSL
mode because its firmware is corrupt, this command must be used.
Example D– 8 Using the Update Command
SCM_E0> power off –par 0
SCM_E0> sho csb
CSB Type Firmware Revision FSL Revision Power State
10 PBM T04.6 (11.03/01:09) T4.2 (09.08) ON
11 PBM T04.6 (11.03/01:09) T4.2 (09.08) ON
12 PBM T04.6 (11.03/01:09) T4.2 (09.08) ON
30 PSM T04.5 (11.03/01:07) T4.2 (09.08) OFF SrvSw: SERVICE
30 XSROM T04.6 (11.03/02:19)
c0 CPU0/SROM T4.2-7 OFF
c1 CPU1/SROM T4.2-7 OFF
c2 CPU2/SROM T4.2-7 OFF
c3 CPU3/SROM T4.2-7 OFF
c0 IOR0 OFF
c1 IOR1 OFF
c2 IOR2 OFF
c3 IOR3 OFF
31 PSM T04.6 (11.03/01:07) T4.2 (09.08) ON SrvSw: NORMAL
31 XSROM T04.6 (11.03/02:19)
c4 CPU0/SROM T4.2-7 On
c5 CPU1/SROM T4.2-7 On
c6 CPU2/SROM T4.2-7 On
c7 CPU3/SROM T4.2-7 On
c4 IOR0 On
c5 IOR1 On
40 HPM T04.6 (11.03/01:11) T4.2 (09.08) ON
e0 SCM MASTER T04.6 (11.03/01:13) T4.2 (09.08) ON
e1 SCM SLAVE T04.6 (11.03/01:13) T4.2 (09.08) ON Ineligible
e2 SCM SLAVE T04.6 (11.03/01:13) T4.2 (09.08) ON Ineligible
e6 SCM SLAVE T04.6 (11.03/01:13) T4.2 (09.08) ON Ineligible
SCM_E0> update –csb 30
Initiate HEX file transfer from host (press ESC-ESC to abort):