Service manual

D-10 AlphaServer GS80/160/320 Service Manual
D.2.4 Terminal Emulator Settings
When the SCM update command is used, firmware update files are
downloaded from a host PC COM1 port to the master SCM local port on
the standard I/O module. Certain terminal emulator settings are
required.
Example D– 5 KEAterm V5.1 Session for PC or Laptop COM1 Port
1. From Start go to Programs and select KEA!VT and then KEA!
2. At the Session Template select Serial – click Next>.
3. At Connection Type select Serial – click Next>.
4. At Connection select the General tab and set
Port name: COM1
Speed: 9600
– click Next>.
5. Then select the Options tab and in the Flow Control section set:
Data to host: Xon/Xoff
Data from host: Xon/Xoff
6. Then select the Rate Limiting tab and deselect (uncheck) both
Limit data rate during Paste and ASCII send and
Limit data rate during keyboard input and reporting
– click Next>.
7. At Terminal Type select VT400-8bit – click Next>.
8. At File Transfer Protocol select ASCII – click Next>.
9. Click Finish to open a KEA terminal session.
10. From the Options menu select History.
Select the VT Advanced tab
Select (check) Auto wrap lines
Click OK.
11. From the File menu select Save Session as
Set Name as something like WF_SCM
Click Save.