Service manual

Firmware Updates D-9
Example D– 3 COM1 Port Settings for Windows 2000
1. From Start go to Settings and select Control Panel.
2. From Control Panel select System.
3. From System select the Hardware tab.
4. From the Hardware tab select Device Manager.
5. Expand Ports and select Communications Port (COM1).
6. At the Communications Port (COM1) Properties, set:
Bits per second: 57600
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: Xon/Xoff
then select Advanced.
7. At the Advanced Settings for COM1, deselect Use FIFO buffers.
8. Click OK back through the dialog boxes. There is no need to reboot.
Example D– 4 COM1 Port Settings for Windows 95
1. From Start go to Settings and select Control Panel.
2. From Control Panel select System.
3. From System Properties select the Hardware Manager tab.
4. Expand Ports and select Communications Port (COM1).
5. At the Communications Port (COM1) Properties, select the Port Settings tab
and set:
Bits per second: 57600
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: Xon/Xoff
then select Advanced.
6. At the Advanced Port Settings, deselect Use FIFO buffers.
7. Click OK back through the dialog boxes. There is no need to reboot.