Service manual

Power-Up Diagnostic Error Table C-43
Test #
hex
ERROR #
<15:0>
FRU(s) Component Failure Description
Remote QBB soft QBB ID configuration test
0001 QBBx (tested) Write/Read of QSA_QBB_ID failed (step 2 of
config process)
0002 Write/Read of QSA_PORT_MAP failed (step 5 of
remote config process)
0003 Write/Read of IOD_CONFIG failed (step 7 of
remote config process)
0004 Invalid Sub-test number received from PSM
0005
HSW0/SCBL
QSA_QBB_POP_1<hs_ready> bit is NOT set
7777 FRU not
determined
GPA CSR (8-bits) Read had bits other than
<7:0> set! Possibly bad GP cable.
37
(13
sub-
tests)
Parameters for error #0001
P1: QSA_QBB_ID read data (read back after the write of QSA_QBB_ID)
P2: QSA_QBB_ID write data (what we expected to read from QSA_QBB_ID)
P3: QSA_QBB_ID address
P4: Target Soft QBB ID in <2:0>. Source Soft QBB ID in <5:3>
Parameters for error #0002
P1: QSA_PORT_MAP_0 read data (read back after the write of QSA_PORT_MAP_0)
P2: QSA_PORT_MAP_0 write data (what we expected to read from QSA_PORT_MAP_0)
P3: QSA_PORT_MAP_0 address
P4: Target Soft QBB ID in <2:0>. Source Soft QBB ID in <5:3>
Parameters for error #0003
P1: IOD_CONFIG read data (read back after the write of IOD_CONFIG
P2: IOD_CONFIG write data (what we expected to read from IOD_CONFIG)
P3: IOD_CONFIG address
P4: Target Soft QBB ID in <2:0>. Source Soft QBB ID in <5:3>
Parameters for error #0004
P1: Subtest number to be Tested P2: Target QBB (Hard QBB# under-test)
P3: System Map passed by the PSM P4: Source Hard QBB ID
Parameters for error number 0005
P1: QSA_QBB_POP_1 CSR read data P2: QSA_QBB_POP_1 CSR address
P3: System Map passed to XSROM in PSM CPU Function Command (bytes 13:10 – CSB spec to
decode)
P4: Source HARD QBB ID
Parameters for error number 7777
P1: GPA CSR address P2: Received GPA CSR Data read
P3: XSROM GP CSR read routine return address P4: Target QBB Soft QBB ID in bits <2:0>