Service manual

Power-Up Diagnostic Error Table C-37
Test#
hex
ERROR #
<15:0>
FRU(s) Component Failure Description
Local QBB soft QBB ID configuration test
0001 QBBx Write/Read of QSA_QBB_ID failed (step 2 of
Local Soft QBB ID config process)
0002 Write/Read of IOD_CONFIG failed (step 3 of
Local Soft QBB ID config process)
0003 Invalid Sub-test number received from PSM.
PSM->XSROM interaction problem (bad PSM
packet).
0099 QSA_PORT_MAP0..3 Read data does not
match data just Written to that CSR during
setup for memory CSR accesses
(mem_csr_acces_init)
7777 FRU not
determined
GPA CSR (8-bits) Read had bits other than
<7:0> set! Possibly bad GP cable.
34
(12
sub-
tests)
Parameters for error #0001
P1: QSA_QBB_ID read data (read back from QSA_QBB_ID) P3: QSA_QBB_ID address
P2: QSA_QBB_ID write data (what we wrote) P4: Source Soft QBB ID in <2:0>
Parameters for error #0002
P1: IOD_CONFIG read data (read back from IOD_CONFIG)
P2: IOD_CONFIG write data (what we wrote)
P3: IOD_CONFIG address
P4: Source Soft QBB ID in <2:0>; Soft QBB ID of QBB under test in <5:3>
Parameters for error #0003
P1: Subtest number
P2: CPU ID in bits <1:0> passed by the PSM. Primary CPU if bit<7> = 1
P3: System Map passed by the PSM
P4: Source Hard QBB ID
Parameters for error number 0099
P1: Data read from QSA_QBB_MAP_0..3
P2: QSA_QBB_MAP_0..3 CSR address just read
P3: Expected Data previously written
P4: Source Soft QBB ID in bits <2:0>; Soft QBB ID of QBB under test in <5:3>
Parameters for error number 7777
P1: GPA CSR address
P2: Received GPA CSR Data
P3: XSROM GP CSR read routine return address
P4: Source Soft QBB ID in bits <2:0>; Soft QBB ID of QBB under test in <5:3>