Service manual

Power Cabinet Component Removal and Replacement 5-29
Removal
Conceivably the system could be running and doing useful work while the
terminal server needs replacing. Essentially what is lost is console control of
the system. Assuming this is the case, there is no need to shut down operating
systems.
1. Open the front door of the power cabinet.
2. Unplug the power cord connected to the back of the terminal server.
3. Unplug the signal cable connecting the terminal server to the SMC PC.
4. Open the rear door of the power cabinet.
5. Unplug the signal cables connecting the terminal server to the standard I/O
module in PCI boxes.
6. Remove the four Phillips head screws holding the terminal server mounting
brackets to the power cabinet frame.
7. Remove the terminal server.
Replacement
Reverse the steps outlined in the removal procedure.
Verification
Verify that each terminal session on the SMC can access the partition to which
it is attached.