Service manual

GS160/320 Component Removal and Replacement 4-37
Removal
1. Remove the target directory or memory module. Follow the procedure
described in Section 4.5.1.
2. Place the module on an anti-static mat on a flat surface with the DIMMs
facing up.
3. Identify the DIMM to replace. Figure 4–12 shows the physical layout of
both the memory module and the directory module.
4. There are locking levers on the end of each DIMM connector
. Open the
levers and gently pull the DIMM from the connector.
Replacement
Reverse the steps outlined in the Removal procedure.
Verification
Power up the system and check that the SCM displays the memory you
replaced.