Service manual

Troubleshooting 3-67
Example 3– 44 Isp1020_diag
P01>>> set d_trace on |
P01>>> set d_group mfg |
P01>>> set d_harderr continue |
P01>>> isp1020_diag pka
isp1020_diag 00000081 pka 1 1 0 0 12:00:01
isp1020_diag 00000081 pka 1 2 0 0 12:00:01
isp1020_diag 00000081 pka 1 3 0 0 12:00:01
The set d_trace command causes the diagnostic output to display on the
console. The set d_group mfg command permits the Acerlab test to be
run. The set d_harderr continue command causes the diagnostic to
continue running even after a hard error.
The isp1020_diag pka command causes the console to run the diagnostic
test suite on the SCSI controller embedded on PCI bus0.
The generic syntax is:
isp1020_diag <device> -p<pass count>
Tests 1 through 3 run on the SCSI controller. Note that this test targets
only Qlogic ISP1020 SCSI controllers. Other SCSI controllers require
other diagnostics.
There are no hard or soft failures in this case.