Service manual

ManualsBrandsCompaq ManualsComputer equipmentAlphaServer 160

221

222

223

224

225

226

227

228

229

230

Troubleshooting 3-49

Example 3– 29 Show_status

P00>>> show_status

ID Program Device Pass Hard/Soft Bytes Written Bytes Read

-------- ------------ ------------ ------ --------- ------------- -----------

00000001 idle system 0 0 0 0 0

0000081c memtest memory 2 0 0 2717908992 2717908992

00000822 memtest memory 2 0 0 2734686208 2734686208

00000828 memtest memory 2 0 0 2701131776 2701131776

00000887 memtest memory 2 0 0 2717908992 2717908992

000008a0 memtest memory 2 0 0 2147344384 2147344384

000008b9 memtest memory 4 0 0 3220881408 3220881408

000008d2 memtest memory 3 0 0 3220979712 3220979712

000008eb memtest memory 1 0 0 0 0

00000905 memtest memory 2 0 0 2147352576 2147352576

0000091e memtest memory 2 0 0 2147352576 2147352576

00000937 memtest memory 2 0 0 2147352576 2147352576

00000940 memtest memory 2 0 0 2147352576 2147352576

00000975 exer_kid dkf0.0.0.1.2 0 0 0 0 4833280

00000976 exer_kid dkg0.0.0.4.2 0 0 0 0 1275392

00000977 exer_kid dkg100.1.0.4 0 0 0 0 1274880

00000978 exer_kid dkg200.2.0.4 0 0 0 0 1274880

0000097c exer_kid dkg300.3.0.4 0 0 0 0 1274880

00000983 exer_kid dkj0.0.0.1.5 0 0 0 0 5041664

000009bf nettest ewa0.0.0.3.0 137 0 0 192896 192896

000009eb nettest ewb0.0.0.6.2 130 0 0 183040 183040

00000a1a nettest ewc0.0.0.6.5 115 0 0 161568 161920

P00>>>

In Example 3–28, some time after sys_exer started, the show_status

command was executed. For a full description of the output, see the

AlphaServer GS80/160/320 Firmware Reference Manual.

Example 3– 30 Kill_diags

P00>>> kill_diags

Loop Reply from: 00-00-f8-1b-1c-0b

Loop Reply from: 00-00-f8-05-f5-50

Loop Reply from: 08-00-2b-c3-c1-c7

P00>>> show_status

ID Program Device Pass Hard/Soft Bytes Written Bytes Read

-------- ------------ ------------ ------ --------- ------------- -----------

00000001 idle system 0 0 0 0 0

P00>>>

In Example 3–30 the kill_diags command is executed, and the show_status

command shows that no diagnostic processes are running now.