Service manual

Troubleshooting 3-11
Table 3– 4 SCM Commands (Continued)
Command Description
help or ?
Display the list of SCM commands
init modem
Initialize the modem (See Table 3–6)
master <cli cmd>
Slave SCM command to master SCM –
allows a slave SCM to pass an SCM
command to the master for the master to
issue
power {off, on} [-all, -partition <n>]
On/off power a partition or the entire
system to system/QBB/H-switch
quit
Switch from SCM-CLI mode COM1 port
reset [-all, -partition <n>]
Reset the system or a particular partition
set flow {com1, local, modem} {hard,
soft, both, none}
Set a port's flow control characteristic
set baud {com1, local, modem} <value>
Set a port's baud rate
set com1_mode {through, snoop,
soft_bypass, firm_bypass, local}
Set COM1 operating mode
show{csb, system, status, fru, nvr}
Show various system information
test {alert, &pc<n> test_num}
Force the sending of an alert message
update {-csb node_address,…}
Update micro flash on CSB node(s)
For details on SCM commands, see the AlphaServer GS80/160/320 Firmware
Reference Manual.