Service manual

Power-Up 2-29
QBB 1 memory, 3 GB |
QBB 2 memory, 3 GB |
QBB 3 memory, 1 GB |
total memory, 11 GB |
copying PALcode to 10bffe8000 |
copying PALcode to 20bffe8000 |
copying PALcode to 303ffe8000 |
Refer to continuation 3 of Example 2–2.
An expanded system map is displayed.
PALcode is loaded and started.
The system configuration is displayed from the SRM console point of view.
The location of the standard I/O module with both the SCM monitor code
and the SRM console code is determined.
The console is started on the system primary CPU. In this case CPU0 in
QBB0.
The CPU’s speed is identified, various firmware variables are created, and
distributed memory is sized and mapped.
The PALcode is copied into memory locations in each QBB making local
references possible.