Installation guide

Consolidating Multi-SMC/AS Configurations to One SMC 7-5
1. Connect appropriate cable (as defined by the instructions that come with
the network hub, not a part of the SMC kits) to network adapter 2 on the
SMC (see Figure 7–4).
2. Connect the other end of the cable to port 1 in the network hub (see Figure
7–5). Note that Figure 7–5 shows an 8-port hub. Hubs with more ports are
available. Also, some network hubs can be daisy-chained to provide more
ports, as described in the instruction booklets that come with the hub.
Figure 7–5 Ports on an 8-Port Network Hub
...
LEDs
Electrical outlet
Port 2
Port 1
8
Front view Rear view
MR0203-01