Installation guide

Cabling an SMC to a Multi-System Configuration 4-11
1. Connect the appropriate cable (as defined by the instructions that come
with the network hub, not a part of the SMC kits) to network adapter 2 on
the SMC (see Figure 4–8).
2. Connect the other end of the cable to port 1 in the network hub (see Figure
4–9). NOTE: The SMC must be connected to port 1, or the SMC will not
work.
Figure 4–9 shows an 8-port hub. Hubs with more ports are available. Also,
some network hubs can be daisy-chained to provide more ports, as described
in the instruction booklets that come with the hub.
Figure 4–9 Ports on 8-Port Network Hub
...
LEDs
Electrical outlet
Port 2
Port 1
8
Front view Rear view
MR0203-01