Installation guide

Cabling an SMC to a Multi-System Configuration 4-9
Figure 4–7 Ports on an 8-port Network Hub
...
LEDs
Electrical outlet
Port 2
Port 1
8
Front view Rear view
MR0203-01
1. Connect one end of each BN25G cable (17–03212–05) to the management
channel connector on the terminal server (
in Figure 4–6).
2. Connect the other end of the cable to any port on the network hub except
port 1, which is reserved for the cable to the SMC. (See Figure 4–7 for an
example of an 8-port network hub. Yours may be different.)