Installation guide

Overview and Preparation 1-7
Figure 1–3 SMC Installation Flowchart (Continued)
Adding AS system
to one or more AS systems
with 1 SMC already
installed?
Condensing
multi-SMC/multi-AS systems
to single SMC?
Ye s
No
Ye s
Run CGValidator
(Chapter 11)
Run ConsoleWorks
to add new group(s)
MR-0215-01
E
Run CGValidator
(Chapter 11)
(No other
choices for
SMC install)
No
(Section 9.2)
Run Access Server
Software
(Chapter 10)
Ye s
No
END END
Plan to run
SMC remotely?
Configure SMC
for remote use
(Chapter 12)
To perform the installation:
1. Install/Upgrade Software. Make sure the SMC software is Version 4.0
(see the AlphaServer GS80/160/320 System Management Console
Installation and Release Notes). If not, take steps to upgrade it.
2. Cable the Hardware. Choose your installation situation from the
possibilities shown in Figure 1–3 on pages 1-4 and 1-5. Refer to the
chapters listed for specific instructions on cabling.
3. Configure the Software. Choose your installation situation from the
possibilities shown in Figure 1–3, pages 1-6 and 1-7. Refer to the chapters
listed for specific instructions.