Installation guide

xiv
• Chapter 6, Adding a System to a Multiple-System Configuration
with One SMC, describes cabling for this situation.
• Chapter 7, Consolidating Multi-SMC/AS Configurations to One SMC,
describes the process (both cabling and software procedures) needed when
you are upgrading your multi-AS, multi-SMC configuration to a multi-AS,
one SMC configuration.
Part 2 – Software Setup. This section of the manual provides instructions on
software setup for the SMC.
• Chapter 8, SMC Definitions, contains procedures for defining the SMC
and its network connections.
• Chapter 9, Create or Update Deault.config File, contains instructions
for creating or updating the file that contains names for the systems and
console lines that will be used by ConsoleWorks.
• Chapter 10, Run Access Server Software, defines IP addresses if you
are installing a new SMC to either a single (partitionable) or multiple
AlphaServer GS80/160/320 configuration, or are upgrading an existing one-
SMC configuration with one or more new AlphaServer GS80/160/320s.
• Chapter 11, Validating Console Groups, describes the procedure needed
to validate the “groups” in the defined configuration. This software (called
Console Group Validator, or CGValidator), physically checks the lines and
displays information about QBBs connected to the lines, and lets you check
off those systems to be partitioned.
• Chapter 12, Configuring the SMC for Remote Use, tells how to set up a
modem and configure the SMC software for remote dial-in.
• Appendix A, Installing a Terminal Server in a GS160/320 System,is
the procedure for upgrading a GS160/320 system from a single console line
to multiple console lines.
• Appendix B, Installing a Terminal Server in a GS80 System,isthe
procedure for upgrading a GS80 system from a single console line to
multiple console lines.