Installation guide

SMC Definitions 8-7
1. In the Network dialog box, select the Protocols tab (Figure 8–4). If the
protocol shown is TCP/IP, skip the rest of this page and go on to Section
8.2.3.
2. If the protocol shown is not TCP/IP, highlight the protocol and click the
Remove button. A message box displays; click Yes.
3. In the Network dialog box, click the Add… button. The Select Network
Protocol dialog box displays (Figure 8–5). Highlight TCP/IP Protocol. Click
OK. A box displays with a message that begins “If there is a DHCP server
on your network….” Click No.
4. The Windows NT Setup dialog box displays. Click Continue.
Figure 8–5 Select Network Protocol Dialog Box