Service manual

Examples 2-3
CAUTION: Always wear an antistatic wrist strap when working on the system.
See Figure 2–1. Using both hands, one on each module lever, place your index
finger on the catch and thumb on the edge of the lever just below/above the
arrow. First squeeze to release the lever and then pull both levers away from
the module to release it from the QBB backplane.
Remove the module. Insert the replacement module and then press the levers
down.
CAUTION: Module should be moved deliberately – without any extra movement
back and forth in the slot – to avoid the discharge of energy. To
avoid causing a system error, close the levers only when the module
is properly seated. Wait 10 seconds before moving the module
again.