QuickSpecs

Operating Systems and
Virtualization Software
Support for ProLiant
Servers
Microsoft Windows Server
Microsoft Windows Server Hyper-V
Red Hat Enterprise Linux (RHEL)
SUSE Linux Enterprise Server (SLES)
Oracle Enterprise Linux (OEL)
Solaris 10 for x86/x64 based Systems
VMware ESX Server
Citrix Essentials for XenServer (Retail)
NOTE: For more information on HP's Certified and Supported ProLiant Servers for OS and Virtualization
Software and latest listing of software drivers available for your server, please visit our Support Matrix at:
http://www.hp.com/go/supportos and our driver download page
http://www.hp.com/support/DL180G6
Rack Airflow Requirements Rack 10000 G2 series Cabinets
The increasing power of new high-performance processor technology requires increased cooling
efficiency for rack-mounted servers. The 10000 G2 Series Racks provide enhanced airflow for maximum
cooling, allowing these racks to be fully loaded with servers using the latest processors.
CAUTION: If a third-party rack is used, observe the following additional requirements to ensure adequate
airflow and to prevent damage to the equipment:
Front and rear doors: If your 42U server rack includes closing front and rear doors, you must allow 830
square inches (5,350 sq cm) of hole evenly distributed from top to bottom to permit adequate airflow
(equivalent to the required 64 percent open area for ventilation).
Side: The clearance between the installed rack component and the side panels of the rack must be a
minimum of 2.75 inches (7 cm).
CAUTION: Always use blanking panels to fill all remaining empty front panel U-spaces in the rack. This
arrangement ensures proper airflow. Using a rack without blanking panels results in improper cooling that
can lead to thermal damage.
Rack Kit HP ProLiant DL180 rack models have fixed rails which provide support for racks with round mounting
holes and tool-free support for racks with square mounting holes (including Compaq/HP 7000, 9000,
10000 and HP series), with an adjustment range of 26" - 36".
Telco Rack Support Support for all 2 and 4 post Telco racks and threaded hole racks requires an additional option kit from
Rack Solutions. The Rack Solutions brackets can be purchased at: www.hp.com/go/rackandpower .
QuickSpecs
HP ProLiant DL180 Generation 6
Standard Features
DA - 13248 Worldwide QuickSpecs — Version 12 — 11.25.2009 Page 13