Installation guide

3-8 Compaq ProLiant 6400R Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Gilbert Saldivar Project: Compaq ProLiant 6400R Setup and Installation Guide Comments:
Part Number: 388776-002 File Name: d-ch03 Installing Hardware Options Last Saved On: 3/20/00 12:17 PM
Table 3-2
Top View of System Board
continued
Item Description
Processor Power Module 3
Processor 4
Processor Power Module 4
CAUTION: Each processor must have an associated PPM installed.
IMPORTANT: If two processors are used with different speeds, install the faster one in
slot 1 and install the slower one in slot 3. Set SW2 and SW3 accordingly.
14. Install the processor:
a. Pushing the processor into the slot until it is firmly until seated .
b. Secure the processor by rotating the ejector levers inward .
c. When the ejectors are seated, complete the installation by tightening
the retention screw
finger-tight.
1
2
2
3
Figure 3-7. Installing the processor
15. Reconnect the power cords to the server.
16.
Verify that the interlock LEDs are normal. See Appendix D, “LED
Indicators.”
17.
Replace the top access panel.