Installation guide

3-2 Compaq ProLiant 6400R Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Gilbert Saldivar Project: Compaq ProLiant 6400R Setup and Installation Guide Comments:
Part Number: 388776-002 File Name: d-ch03 Installing Hardware Options Last Saved On: 3/20/00 12:17 PM
■
Hot-Plug Area Access - This section covers the procedures for
accessing areas in which to install hot-plug options, upgrades or
replacements. These areas include: five PCI Hot Plug expansion slots,
hot-plug SCSI drive bays, hot-plug power supplies, and hot-plug fans.
Non-Hot-Plug Area Access
The following section provides instructions on accessing non-hot-plug areas of
the server. Access these areas to install hardware options and upgrade or
replace certain components.
Tool Needed:
Torx T-15 screwdriver (included with the server)
Accessing and Installing Processors
WARNING: To reduce the risk of electric shock or damage to the equipment:
■ Disconnect power from the server by unplugging all power cords from
either the electrical outlet or the server.
■ Leave the power cord grounding plug in place. The grounding plug is an
important safety feature.
■ Plug the power cord into a grounded (earthed) electrical outlet that is
easily accessible at all times.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching them.
CAUTION: Electrostatic discharge can damage electronic components. Ensure
that you are properly grounded before beginning any installation procedure.