Installation guide

2-20 Compaq ProLiant 6400R Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Gilbert Saldivar Project: Compaq ProLiant 6400R Setup and Installation Guide Comments:
Part Number: 388776-002 File Name: c-ch02 Rack-Mountable Server Installation Last Saved On: 3/17/00 1:41 PM
8. Secure the server face plate to the front of the rack by screwing the
thumbscrews into the cage nuts.
9. Tighten the thumbscrews before you close the rack door to prevent the
door from hitting protruding thumbscrews.
Attaching the Cable Management Arm Bracket
and Cable Management Arm
Installing the Cable Management Arm Bracket
The cable management arm bracket fastens to the rear of the rack server
chassis. The bracket provides an attachment point for the cable management
arm from the server to the rear frame of the rack.
Attach the cable management arm bracket to the back of the server with two
6-32 × 0.312 Torx screws.
Figure 2-11. Attaching a cable management arm bracket to the server
Attaching the Cable Management Arm
A double-hinged cable management arm and fasteners ship with each server.
The cable management arm attaches to the server cable management arm
bracket and to the rear frame of the rack. All cables to and from the server are
tied to the arm. The two hinges enable the cable management arm with
attached cables to swing out of the way when you need to access the rear of
the server.