Installation guide

2-18 Compaq ProLiant 6400R Setup and Installation Guide
Compaq Confidential – Need to Know Required
Writer: Gilbert Saldivar Project: Compaq ProLiant 6400R Setup and Installation Guide Comments:
Part Number: 388776-002 File Name: c-ch02 Rack-Mountable Server Installation Last Saved On: 3/17/00 1:41 PM
Attaching Handles to the Server
1. Align the rack mounting handles on the side of the server.
2. Attach the rack mounting handles with screws.
IMPORTANT: Your server may vary from the one shown in Figure 2-10. However, the
process of attaching the handles to the server is the same.
Figure 2-9. Attaching rack mounting handles to the server
Installing the Server into the Rack
Load and secure the server to the rack with the face plate thumb screws before
attaching any more mounting bracket assemblies. Ensure that the pair of
brackets is perfectly aligned and installed and that the server fits before you
continue.
WARNING: To reduce the risk of personal injury or damage to the equipment, a
minimum of two people MUST lift the server into the rack. The server may
weigh 75 lb (34 kg). If the unit is to be loaded above chest level, a third person
MUST assist in aligning the rails while the other two support the unit.
IMPORTANT: To reduce the weight of the server and make it more manageable, do not
install drives until after you load the server into the rack.
1. Pull the slide rails forward from the mounting brackets to a fully
extended position.
2. Set the server handles on the extended slide rails.