Specifications

Diagnostic Tools 3-15
For use with Pentium II and Pentium III Xeon processor-based servers only
Table 3-2
POST Error Messages
continued
Error Code
Audible Beeps
L=Long S=Short
Probable Source of Problem Recommended Action
1773-Primary Fixed
Disk Port Assignment
Conflict
None Fixed disk drive error. Run the System Configuration
Utility and correct.
1774-Slot x Drive
Array - Obsolete data
found in Array
Accelerator.
Select F1 to discard
contents of Array
Accelerator.
Select F2 to write
contents of Array
Accelerator to drives.
None SMART-2 Controller error. Data found in Array Accelerator
is older than data found on
drives. Press F1 to discard the
older data in the Array
Accelerator and retain the
newer data on the drives.
1775-Slot x Drive
Array – ProLiant
Storage System Not
Responding SCSI
Port (y): Check
storage system
power switch and
cables. Turn the
system power off
while checking the
ProLiant power and
cable connections,
then turn the system
power back on to
retry.
None Storage system problem. Turn off power to system.
Check external ProLiant power
switch – external drives must all
be powered up before or at the
same time as the main system.
Check cables. If retry does not
help, try replacing the cable,
ProLiant firmware, ProLiant
backplane, or the Smart Array
Controller.
1776-Drive Array -
SCSI Port
Termination Error
None External and internal SCSI drives
are both configured to Port 1.
Reconfigure drives.
1777-Drive Array
External Drive
Subsystem Error
None Cooling fan failure, internal
temperature alert or open side
panel.
Inspect for cooling fan failure or
open side panel.
1778-Drive Array
resuming Automatic
Data Recovery
process
None This message appears whenever
a controller reset or power cycle
occurs while Automatic Data
Recovery is in progress.
No action necessary.
1779-Drive Array
Controller detects
replacement drives
None Intermittent drive failure and/or
possible loss of data.
If this message appears and
drive X has not been replaced,
this indicates an intermittent
drive failure. This message also
appears once immediately
following drive replacement
whenever data must be restored
from backup.
1780-Disk 0 Failure None Hard drive/format error. Run Diagnostics. Replace failed
assembly as indicated.
continued