Specifications

3-8 Compaq ProLiant 5500 and 5500R Maintenance and Service Guide
For use with Pentium II and Pentium III Xeon processor-based servers only
Table 3-2
POST Error Messages
Error Code
Audible Beeps
L=Long S=Short
Probable Source of Problem Recommended Action
A Critical Error
occurred prior to this
power-up
None A catastrophic system error,
which caused the server to
crash, has been logged.
Run Diagnostics. Replace failed
assembly as indicated.
Unsupported
Processor Detected
System Halted
1L, 1S Processor not supported by
current system ROM.
Check documentation for
supported processors, and if
supported, remove the
processor and update the
system to latest ROM.
FATAL ROM ERROR:
The System ROM is
not properly
programmed
1L, 1S ROM programmed in factory
incorrectly.
Replace the physical ROM part.
101-ROM Error 1L,1S System ROM checksum. Run Diagnostics. Replace failed
assembly as indicated.
101-I/O ROM Error None Options ROM checksum. Run Diagnostics. Replace failed
assembly as indicated.
102-System Board
Failure
None DMA, timers, and so on. Replace the system board. Run
the Compaq System
Configuration Utility.
104-ASR-2 Timer
Failure
None System board failure. Run Diagnostics. Replace failed
assembly as indicated.
105-Current System
ROM is corrupt –
now booting
redundant System
ROM
2L Non-booted ROM image is
corrupt.
Flash the ROM utilizing
ROMPaq.
162-System Options
Not Set
2S Configuration incorrect. Run the System Configuration
Utility and correct.
163-Time & Date Not
Set
2S Invalid time or date in
configuration memory.
Run the System Configuration
Utility and correct.
164-Memory Size
Error
2S Configuration memory incorrect. Run the System Configuration
Utility and correct.
172-Configuration
Nonvolatile Memory
Invalid
None Nonvolatile configuration corrupt
or jumper installed.
Run the System Configuration
Utility and correct.
173-Slot ID
Mismatch
None Board replaced, configuration not
updated.
Run the System Configuration
Utility and correct.
174-
Configuration/Slot
Mismatch Device Not
Found
None EISA or PCI board not found. Run the System Configuration
Utility and correct.
continued