Specifications

Diagnostic Tools 3-65
For use with Pentium II and Pentium III Xeon processor-based servers only
Remote Service Features
Compaq servers have the following management features that you can access via modem or
network:
Table 3-28
Compaq Servers Remote Management Features
Feature Description
Service Session Provides remote access to all the utilities on the system partition, including
Diagnostics utilities, Inspect, ROMPaq, Drive Array Advanced Diagnostics (DAAD),
and the System Configuration Utility. Also provides the capability for remote file
transfer services to and from the system partition.
Disk-Based Diagnostics Provides remote diagnostic capability after you configure ASR-2 and the reset
restart option to restart from Compaq Utilities. Also allows you to view Health Logs.
Disk-based diagnostics can also be run locally. Press F10 during the restart
process when the cursor moves to the upper-right corner of the monitor.
Server Restart Provides the ability to restart the server remotely from Compaq Insight Manager
while the operating system is running. Allows the server to restart back to the
operating system or restart to the system partition. Provides a complete system
reset to all peripherals. If you select Boot to Compaq Utilities from Compaq Insight
Manager, Compaq Utilities loads the appropriate remote services so that remote
access is available. If network status is enabled, network support is loaded. If Dial-
In status is enabled, the modem is set to auto-answer.
Configuration Utility
Allows you to run the remote System Configuration Utility locally. Press F10 during
the restart process when the cursor moves to the upper-right corner of the monitor.
Firmware Updates Allows you to update the server firmware remotely. Uses firmware images on the
system partition that might have been previously uploaded with the file transfer
services.
ROMPaq Error Recovery Options
From time to time it may be desirable to upgrade the current system ROM. Some reasons for
this may be as follows:
■ Customer desires ROM upgrade
■ Obtained new SmartStart CD-ROM
■ Desire to upgrade server processors
■ Request from Compaq
The process of upgrading the system ROM is referred to as flashing the ROM. Flashing consists
of using software to replace the current ROM image with a new one through ROMPaq.
Should an error such as a power failure occur during this process, the flash operation will not be
completed, causing the ROM image to be corrupted. Compaq provides two options for ROMPaq
recovery, depending on the server and circumstances involved.