Technical data

• Flow Control: None
After the terminal, or terminal emulator is set up, type an
Enter or two to
obtain the CLI> prompt.
The MSA1000 accepts CLI commands in upper- or lowercase. All commands
will be typed in uppercase in this document.
See the hp StorageWorks modular SAN array 1000 user guide for more
information on CLI commands than is provided in this technical update.
______________________ Note _______________________
MSA1000 commands must be typed completely; they cannot be
abbreviated.
4.8 Preparing the Storage for Tru64 UNIX and TruCluster
Server Software Installation
Storage for the example two-member TruCluster Server cluster configuration
is allocated as shown in Table 4-2.
Table 4-2: Storage Considerations for Example Installation
File System or Disk Size
Unit
Number Unit ID Device Name
a
dskn
b
Tru64 UNIX disk 2 GB
1 101
dga101.1001.0.7.0
73
Cluster root (/)2GB
2 102
N/A
c
74
Cluster /usr 8GB
3 103
N/A
c
75
Cluster /var 6GB
4 104
N/A
c
76
Quorum disk 1 MB
5 105
N/A
c
77
Member 1 boot disk 3 GB
6 106
dga106.1001.0.7.0
78
Member 2 boot disk 3 GB
7 107
dga107.1001.0.7.0
79
a
The device names are defined in Section 4.9.
b
The dskn names must be added to the table when they are discovered during the installation (see Section 4.10.1), or by
use of the hwmgr command as shown in Section 4.10.3.
c
These units are not assigned an alias for the device unit number by the WWID manager command; therefore, they do not
get a device name and will not show up in a console show dev display.
As you proceed through the installation, fill out Table A-2 with information
specific for your cluster.
4-10 Preparing the MSA1000 for TruCluster Server Use