Technical data

Chapter 7
Configuration Example Using CLI
This chapter presents an example of how to configure a storage subsystem using the
Command Line Interpreter (CLI). The CLI configuration example shown assumes:
■ A normal, new controller pair, meaning:
❏ NODE ID set
❏ No previous failover mode
❏ No previous topology set
■ Full array with no expansion cabinet
■ PCMCIA cards installed in both controllers
A storage subsystem example is shown in Figure 7–1. The example system contains three
non-clustered TRU64_UNIX hosts, as shown in Figure 7–2. From the hosts’ point of
view, each host will have four paths to its own virtual disks. The resulting virtual system,
from the host’s point of view, is shown in Figure 7–3.