Technical data

5–14 HSG80 ACS Solution Software Version 8.6 for Compaq Tru64 UNIX Installation and Configuration Guide
The first connection will have one or more entries in the connection table. Each
connection will have a default name of the form !NEWCONxx, where xx is a number
representing the order in which the connection was added to the connection table.
For a description of why plugging in one adapter can result in multiple connections,
see “Numbers of Connections,” page 1–13.
15. Rename the connections to something meaningful to the system and easy to remember.
For example, to assign the name ANGEL1A1 to connection !NEWCON01, enter:
RENAME !NEWCON01 ANGEL1A1
Compaq recommends using a naming convention, see “Naming Connections,” page
1–13.
16. Specify the operating system for the connection:
SET ANGEL1A1 OPERATING_SYSTEM=TRU64_UNIX
17. Verify the changes:
SHOW CONNECTIONS
Mark or tag all Fibre Channel cables at both ends for ease of maintenance.
Repeat Procedure for Each Host Adapter Connection
18. Repeat steps 15, 16, and 17 for each of that adapter’s host connections or delete the
unwanted connections from the table.
19. For each host adapter, repeat steps 14 through 18.
Verify Installation
To verify installation for your Tru64_UNIX host, enterone of the following commands:
For V4.0G Use
file /dev/rrx*c | grep HSG80
For V5.1x Use
file /dev/cport/ *
Your host computer should report one CCL device special file for each HSG80 configured.