Technical data

5–4 HSG80 ACS Solution Software Version 8.6 for Compaq Tru64 UNIX Installation and Configuration Guide

Figure 5–2. Single controller cabling

Configuring a Single Controller Using CLI

To configure a single controller using CLI involves the following processes:

■ Verify the Node ID and Check for Any Previous Connections.

■ Configure Controller Settings.

■ Restart the Controller.

■ Set Time and Verify all Commands.

■ Plug in the FC Cable and Verify Connections.

■ Repeat Procedure for Each Host Adapter.

■ Verify Installation.

Verify the Node ID and Check for Any Previous

Connections

1. Enter a SHOW THIS command to verify the node ID:

SHOW THIS

1 Controller

2 Host port 1

3 Host port 2

4 Cable from the switch to the host Fibre Channel adapter

5 FC switch

CXO6881B