Technical data

Installing and Configuring the HS-Series Agent 4–5
Before Installing the Agent
1. Log in as root (superuser). Agent installations on Tru64 UNIX must be done locally.
Do not attempt to install the Agent over the network.
2. Remove previous versions of the Agent from your computer.
3. Read the release notes.
CAUTION: Do not install the Agent by using Dataless Management Services (DMS) or
Remote Installation Services (RIS) sever installations.
Installing and Configuring the Agent
The following instructions assume that you have a directory /mnt to which you can mount
the CD-ROM. If you do not, you must create a mount point and replace /mnt in the
following sequence with the mount point you created. It also assumes your CD-ROM
device is /dev/rz4c. If not, replace /dev/rz4c with the actual CD-ROM device.
IMPORTANT: Before you install the Agent, complete the steps in “Before You Install the Agent.”
1. Obtain the following information:
❏ Names of systems you want the Agent to contact
❏ Names of subsystems connected to the host
❏ Email addresses for the Agent to send status updates
2. Insert the CD-ROM into a computer.
3. Enter one of the following commands at the command prompt:
❏ For V4.0x enter:
# mount -r-t cdfs -o rrip /dev/rz6c /mnt
(Substituting rz6c if necessary for your CD-ROM)
❏ For V5.1x enter:
# mount -r-t cdfs /dev/disk/cdrom0c /mnt
(Substituting cdrom0c if necessary for your CD-ROM)