Technical data

3–8 HSG80 ACS Solution Software Version 8.6 for Compaq Tru64 UNIX Installation and Configuration Guide
For V4.0G
# mount /dev/rza8c /mnt
For V5.1x
# mount /dev/disk/dsk8c /mnt
To view the mounted filesystem, enter:
# df
The LUN is now accessible to the filesystem just as a disk device would be. The
filesystem can not see the RAID functionality and number of physical devices attached to
the HSG80 controller. This device appears as a single LUN or “disk” to the user as viewed
by the filesystem.
DECsafe Available Server Environment
(ASE)
HSG80 disk devices can be used with the DECsafe Available Server Environment (ASE)
for Tru64 UNIX provided a valid Host configuration (including Host adapters) is used to
support them. Refer to the Tru64 UNIX ASE Installation and User’s Guide, Software
Product Description, SPD: 44.17.xx, for further information. Refer to the Release Notes
for supported host adapters and Tru64 UNIX version levels for ASE.
Using genvmunix
NOTE: This section on genvmunix does not apply to Tru64 UNIX V5.1x, since the configuration
file has a different format for devices.
If you use genvmunix to initialize the system and doconfig to build a new configuration
file, the new configuration file will only list the HSG80 LUN 0 units; nonzero LUNs will
not appear in the new configuration file.
Before rebuilding a configuration file using genvmunix, save any existing customized
configuration file that has entries for HSG80 units. After rebuilding the configuration file,
add the entries from the saved configuration file to the new configuration file.