User guide

Managing remote servers through the Serial Session Viewer 154
3.
In the Default Login Timeout field, enter the number of seconds the Serial Session Viewer waits for a
valid response to automatic login information, in the range 1 to 99999. The default value is 30
seconds.
4. In the Initial character dropdown list, select: CR (carriage return), CR+LF (carriage return and
linefeed), CR+CR (carriage return and carriage return), ESC (Escape), CTRL+P (Control+P sequence,
0x10 in hex), or None (no initial transmission character). The default value is None.
5. In the first Expect field, enter the 1 to 32 alphanumeric character string that you expect from the unit.
Spaces are allowed. The Manage Console Switch Default Values lists the serial console switch
default values.
6. In the first Send field, enter the 0 to 32 alphanumeric character string to be sent in response to the
Expect string. Spaces are allowed, and a blank field is valid. A CR or CR+LF is appended to the
string, based on the New Line Mode - Outbound setting. If a Send field contains an entry, the Expect
field cannot be blank. The Manage Console Switch Default Values lists the serial console switch
default values.
You can use the following macros in the field. The HP IP Console Viewer automatically replaces
these variables when the login script runs.
Macro are replaced with:
• %U user name
• %W Password
7. Enter additional Expect and Send field entries, as needed, to a maximum of four each.
8. In the Success String field, enter the string that indicates the login was successful. This field must
contain a value when automatic login is enabled.
9. In the Failure String field, enter the string that indicates the login was unsuccessful. This field must
contain a value when automatic login is enabled.
10. Select or clear the Press the Reset to Default button checkbox to reset the login script to its
default content. The default values are restored and displayed.
11. Click OK to exit the dialog box and save any changes.
-or-
Click Cancel to exit the dialog box without saving any changes.
Field Default value
Initial character None
First expect user name:
First send %U
Second expect Password:
Second send %W
Success string Authentication complete
Failure string Invalid login
Enabling or disabling automatic login
1. Select Options>Sessions.
-or-
Click Session Settings.