Specifications

4. Rotate the drive cage back down to its normal position.
Figure 6-29 Rotating the Drive Cage Down
5. Slide the drive back until it stops, then lift it up and out of the drive cage.
Figure 6-30 Removing a 3.5-inch Drive (Media Card Reader Shown)
NOTE: When replacing a 3.5-inch drive, transfer the four mounting screws from the old drive to the
new one.
Installing a Drive into the 3.5-inch Internal Drive Bay
The 3.5-inch bay is located underneath the 5.25-inch drive. To install a drive into the 3.5-inch bay:
1. Follow the procedure in
Removing an Internal 5.25-inch Drive on page 59 to remove the 5.25-
inch drive and access the 3.5-inch drive bay.
CAUTION: Ensure that the computer is turned off and that the power cord is disconnected
from the electrical outlet before proceeding.
2. If you are installing a drive in a bay covered by a bezel blank, remove the front bezel then
remove the bezel blank. See
Bezel Blanks on page 43 for more information.
Drives
65