Specifications

The 3.5-inch drive is located underneath the 5.25-inch drive. You must remove the internal 5.25-inch
drive before removing the internal 3.5-inch drive.
1. Follow the procedure in
Removing an Internal 5.25-inch Drive on page 59 to remove the 5.25-
inch drive and access the 3.5-inch drive.
CAUTION: Ensure that the computer is turned off and that the power cord is disconnected
from the electrical outlet before proceeding.
2. If you are removing a media card reader, disconnect the USB cable from the system board.
Figure 6-27 Disconnecting the Media Card Reader USB Cable
3. Rotate the drive cage to its upright position (1) and remove the mounting screw on the back left
side of the drive (2).
Figure 6-28 Removing the Drive Mounting Screw
64 Chapter 6 Removal and Replacement Procedures Small Form Factor (SFF) Chassis