Specifications

Installing an Optical Drive into the 5.25-inch Drive Bay
To install an optional 5.25-inch optical drive:
1. Prepare the computer for disassembly (
Preparation for Disassembly on page 40).
2. Remove the access panel (
Computer Access Panel on page 41).
3. If you are installing a drive in a bay covered by a bezel blank, remove the front bezel then
remove the bezel blank. See
Bezel Blanks on page 43 for more information.
4. Install three M3 metric mounting screws in the lower holes on each side of the drive: two on the
right side and one on the front left side. HP has provided extra M3 metric mounting screws on
the front of the chassis, under the front bezel. The M3 metric mounting screws are black. Refer
to
Installing and Removing Drives on page 57 for an illustration of the extra M3 metric mounting
screws location.
CAUTION: Use only 5-mm long screws as mounting screws. Longer screws can damage the
internal components of the drive.
NOTE: When replacing the drive, transfer the three M3 metric mounting screws from the old
drive to the new one.
Figure 6-22 Installing Mounting Screws in the Optical Drive
Drives
61