User guide

Installing the Operating System Drivers 7-13
Accessing the Information
To access the driver installation information:
1. Place the diskette labeled Documentation Diskette in the diskette drive
of a server or PC. If you wish to print the information file this system
must of course be connected to a printer.
2. Reboot the system.
3. Select the file named README.HBA to view or print.
4. Follow the instructions in this file to install the Smart Array 431
Controller driver in an existing UnixWare server.
Proceed to the last section in this chapter, “Updating the Compaq Insight
Management Agents.”
IBM OS/2
Installing the Driver
The instructions in this section may be used to install the initial driver for a
new Smart Array 431 Controller installation or to upgrade the driver in an
existing OS/2 server/Smart Array 431 Controller system. If you use SmartStart
to install OS/2 and drivers on a new server, you can skip this section and you
do not need to create the OS/2 SSD.
Creating a Support Software Diskette (SSD)
The OS/2 driver for the Smart Array 431 Controller is located on the Compaq
SmartStart and Support Software CD that was supplied in the Smart Array 431
Controller Option Kit. To gain access to the driver you first need to create the
OS/2 SSD. This diskette contains the latest operating system software, drivers,
and supporting documentation for all Compaq equipment supported by OS/2.
To create this diskette:
1. Boot the server from the Compaq SmartStart and Support Software
CD.
2. Select Create Support Software from the Compaq System Utilities screen.
3. Select Create Support Software Diskettes from CD only from the
Diskette Builder screen.
4. Scroll down the list and select Compaq OS/2 2.x Support Software.
5. Follow the instructions on the screen to create the OS/2 SSD diskette.