User guide

Installing the Operating System Drivers 7-11
Accessing the Information
Driver installation procedures for SCO OpenServer 5 from Compaq and SCO
OpenServer 5 (non-Compaq) are different. Choose the correct procedure
below.
Servers Running Compaq SCO OpenServer 5
To access the driver installation information for systems running SCO
OpenServer 5 from Compaq:
1. Place the diskette labeled SCO Installation Notes for Compaq Servers
in the diskette drive of a server or PC capable of reading a DOS text
file.
2. Use a text editor or other DOS utility to read the INSTALL.TXT file on
the diskette.
3. Follow the instructions in this file to install the Smart Array 431
Controller driver in a server running SCO OpenServer 5 from Compaq.
Servers Running Non-Compaq
SCO OpenServer 5
To access the driver installation information for systems running non-Compaq
SCO OpenServer 5:
1. Place the diskette labeled Documentation Diskette in the diskette drive
of a server or PC. If you wish to print the information file this system
must of course be connected to a printer.
2. Reboot the system.
3. Select the file named INSTALL.TXT to view (Enter) or print (F7).
4. Follow the instructions in this file to install the Smart Array 431
Controller driver in a server running non-Compaq version of SCO
OpenServer 5.
Proceed to the last section in this chapter, “Updating the Compaq Insight
Management Agents.”