User guide

Installing the Operating System Drivers 7-9

Enter the following:

A:\setup

Select Custom.

Select the Compaq Smart Array 322DC/42XX Controllers component.

If you have previously installed this driver on your system, Setup

indicates whether the driver can be updated - click Update to do so. If

you have not installed the driver, click Install to do so. Insert the correct

diskettes as prompted during the installation.

You can install other components through Setup, or click Close if you

are done. Setup prompts you to reboot the system to load the newly

installed or updated driver.

Removing the Smart Array 431 Driver

Removal of Compaq drivers can only be done through the Control Panel.

IMPORTANT: Do not remove this driver if the system is booting from a device attached

to a Smart Array 431 Controller. You will get a dialog box stating the selected controller is

marked as a boot device. Removing it may cause the system not to boot.

Start Windows NT and log in to an account with administrative

privileges.

From the Control Panel, launch the SCSI Adapter Utility.

Select the Drivers tab.

Select the Compaq Smart Array 322DC/42XX Controllers, then click

Remove.

After the driver has been removed, click OK. You must reboot for the

removal to take effect.