User guide

6-4 Compaq Smart Array 431 Controller User Guide
Deleting a Logical Drive
If there is a single existing logical drive already configured on the array
controller, you will be given the option to delete the logical drive.
■ Press F3 to delete the logical drive
And
■ ESC to exit the utility
Confirmation Screen
The Confirmation screen is shown as a pop-up panel on top of the last screen.
Figure 6-2. Confirmation screen
Array Configuration Utility
This section provides instructions for using the Compaq Array Configuration
Utility; and it describes methods (wizards) you can use to configure your
controller quickly and easily. This section is divided into seven sub-sections,
listed below. You should read the first five subsections and use the last two as
reference material when needed.
■ Before You Begin
■ Starting the Compaq Array Configuration Utility
■ Configuration Wizards
■ Online Help
■ Configuration Procedures
■ Array Configuration Utility screens
■ Errors and Warnings
You have selected a logical drive with a total
data size of 8.6GB and RAID 5 fault tolerance.
An Online Spare has also been selected.
Press <F10> to save the configuration and exit
Press <Esc> to cancel